PROTECTION FROM ELECTRIC SHOCK
﹡Connect the product to AC mains power within the range 90-264V
nominal at 50 or 60 HZ only.
﹡Disconnect the product from power when not in use.
﹡Always ground (earth) the product electrically
﹡ Before using the product, check that all power distribution
equipment and cables are in perfect condition and rated for the
current requirements of all connected devices.
﹡Do not use the product if the power cable or a power plug is in any
way damaged, defective or showing signs of overheating.
﹡Do not attempt to open any cover.
﹡Refer any service operation not described in this manual to a
qualified technician.
PROTECTION FROM FIRE
Do not stick filters, masks or other material directly onto LED
models.
Do not modify the product in any way not described in this manual.
Install only genuine Radiant parts in or on the product unless an
alternative is described in this manual.
Do not operate the product full load if the ambient temperature of
power units exceeds 60°C（156°F）
To Next Page
Loading...