ENGLISH
43
www.trapp.com.br
There are 5 different cutting heights.
Models SL-30T / SL-30E / TS-70T /
TS-70E / CG-40E
To adjust cutting height pull axle toward you and
set to desire cutting height see figure below:
Grass cutting height
1- Higher
2- Medium
3- Lower
Models KM / RS
To adjust cutting height proceed as follows:
Flex handle towards the wheel (1) releasing the
lock, then move handle to the right or to the left (2)
according to desired cutting height.
There are 5 different cutting heights.
Simultaneous adjustment of cutting height in the 4
wheels.
To avoid engine overload, select the cutter edge
height according to yard condition.
For the types of grass used in Brazil, it is
recommended to keep them 2 and 3 cm high
from soil. If lawn is excessively high, perform 2 or
more cutting with different height adjustments. This
procedure will help to improve equipment life, thus
avoiding a blow out due to electric engine overload.
According to cutter model (with or without grass-
holder, with side outlet), use a cutting sense as
shown in the illustrations below.
To Next Page
Loading...
