Do you have a question about the Traxxas Villain EX 1502 and is the answer not in the manual?
Scale | 1/10 |
---|---|
Speed | 20+ mph |
Hull Material | ABS plastic |
Drive System | Direct drive |
Type | RC Boat |
Height | 7 inches |
Motor | 550 |
Battery | 7.2V NiMH |
Radio System | TQ 2.4GHz |
Charger | Included DC charger |
Propeller | 3-blade |
Recommended Environment | Ponds, lakes |
Explains icons used for warnings, tips, and cross-references in the manual.
Provides contact details for Traxxas technical support and service.
Lists crucial safety rules and warnings for operating the boat.
Details suitable locations and environmental conditions for boat operation.
Lists the necessary tools and supplies for operating and maintaining the model.
Specifies the types of batteries required for the transmitter and boat.
Steps for charging and installing the batteries for the boat and transmitter.
Covers antenna installation, radio checks, and initial driving.
Step-by-step guide for applying decals to the boat.
Advice on painting the boat's hull for aesthetic enhancement.
Illustrates the electrical connections within the boat's radio system.
Explains the functions of the transmitter and receiver controls.
Details adjustments for throttle, steering, and servo reversing.
Instructions for properly charging the NiCd/NiMH battery packs.
Procedures for installing batteries and advice on choosing the right ones.
Explains the primary controls on the transmitter.
Covers throttle neutral, trim, and servo reversing adjustments.
Steps for checking and confirming the radio system's function.
Procedure for verifying radio range before each use.
Steps for adjusting the transmitter and programming the speed control.
Guidelines for using non-factory transmitters with the EVX.
Factors affecting run time and tips to increase it.
Methods for boat retrieval and troubleshooting propeller cavitation.
How to adjust outdrive trim for optimal speed and stability.
Steps to adjust the shaft end play for proper outdrive function.
Guide for inspecting, maintaining, and storing the boat.
Procedure for re-centering the steering servo after service.