Need help?Do you have a question about the Traynor INTERNATIONAL and is the answer not in the manual?
Risk of electric shock, do not open, no user-serviceable parts inside. Refer servicing to qualified personnel.
General warnings and precautions for safe operation of electrical products, including power sources, hazards, and cord safety.
Connect to specified voltage, use polarized plug correctly, ensure grounding is not defeated.
Avoid unstable surfaces, liquids, naked flames, ensure ventilation, and use proper mounting accessories.
Route the AC supply cord to prevent damage. Do not operate the unit if the cord is damaged.
Refer all servicing to qualified service personnel only.
Advice on placement near power sources and heat for optimal performance and to avoid interference.
LED indicator, voltage check before connecting, and volume adjustment before power cycling.
High input for higher sensitivity, Low input for lower impedance or maximum gain.
These controls adjust the output level and distortion on guitar amplifiers.
Turns the distortion or overdrive effect on and off.
Regulates the amount of distortion or overdrive on guitar amplifiers.
Affects the overall output volume of the amplifier for desired sound.
Gain controls preamp level for distortion; Channel Select switches signal path.
Gain controls preamp level for distortion; Volume controls overall loudness.
High, Mid, and Low controls for adjusting frequency response and tonal shaping.
Adds edge and definition to the guitar sound.
Adjusts the amount of reverberation effect applied to the signal.
Adjusts the amount of chorus effect for a stereo sound.
Provides a preamp signal output for connecting to a PA or recording mixer.
Stereo headphone output jack that mutes the internal speaker.
Adds sonic low-frequency presence, particularly useful for bass players.
Output to drive external effects at a suitable level, pre-Reverb signal shaping.
Input for external effects, signal is post-Tone Controls processing.
Allows external control (on/off) of the internal Reverb effect.
Enables switching between input channels via an external footswitch.
Connect external speakers; automatically disables the internal speaker.
Transferable, no registration needed. Free repair within two years of original purchase date.
To Next Page
General
