LCT SERIES Operation Manual
16
Rev 3, 5.30.17
Press “Qty. Set” key, check that the display shows “CH-ON”. (To change from on or off,
press the “Zero” button.)
Once the CH-On is displayed, set the lower count to the desired quantity using the
number key. (Using the 1000 qty. example the lower limit would be 999.)
To set the upper count limit press the “Tare” key and set the desired quantity. (Using the
1000 qty. example, the upper limit would be 1001.)
Press “Qty. Set” to confirm the information entered and return to count mode. The Scale
is ready for weighing.
Note: If “CH=ON” was previously set, the alarm will sound if the count pieces limit is
meet.
Setting weight units
Without any weight placed on the platform, press the “sample unit” key to select the unit
(kg or lb.).
Activating the Alarm
When the scale is turned off, press and hold “Unit Weight” key to turn on the scale, then
press “Qty. Set” key to activate(b-ON) or deactivate (b-OFF) the function of the beeper.
Activating the display backlight
When the scale is turned off, press and hold the “Unit Weight key to turn on the scale,
then press “Zero” key to select L-ON, L-AU(for auto) or L-OFF for the backlight function.
Automatic stand-by
When the scale is turned off, press and hold the “Unit Weight key to turn on the scale,
then press the “Tare” key to select automatic stand-by. To return back to normal
operation press the power button twice.
Memory storage (M1 to M9)
Turn on the scale, then select the unit of measure (kg. or lb.) by pressing the
“sample unit” key.
To store the information, press the “store” key and then the memory key you
want to use to save the information.
Process is complete, repeat steps above, to store memory values for the rest of
the memory keys.
Press “CE” to clear the display.
Press M1 to M9 to recall each pre-stored unit weight from memory.
Memory Clear (M1 to M9)
Press the “CE” key and the display will show “0”
Then press the “Store” key to display “CO” immediately press “M1” to clear the
memory of M1. The display will show a dashed line on the total (pcs.) column.
To clear the memory for the rest of the memory keys repeat the above steps.
Total Weight Pieces
To clear the total pieces from the memory “M+” once storage is full.
Press the “Total” key to display the total pieces count
Then press the “MC” Key to clear the displayed total pieces.
Press the “CE” key to confirm the process.
Calibration
To Next Page
Loading...
