treesse Muse GP - Page 21

21
EN
Muse GP minipool
SYSTEM
MESSAGES
DISPLAY
SCREEN
DESCRIPTION OF SIGNALS AND POSSIBLE SOLUTIONS
Memory fault -
Checksum
error* - M022
Problem description: At power up, the system did not pass the check-
sum (system integrity check). This indicates a problem in the operating
system.
Solutions: Contact Technical Service.
Memory
alarm - Memory
cancellation* -
M021
Problem description: It appears after every change made to the system.
Solutions: Contact Technical Service if this message
appears more than once during power up or if it appears after a period
of normal operation.
Memory fault -
Clock error -
M020 - Not
applicable on
BP1500
Solutions: Contact Technical Service.
Conguration
error - The
minipool doesn’t
start
Solutions: Contact Technical Service.
GFCI fault – The
system is not
connected to the
GFCI – M036
Problem description: ONLY IN NORTH AMERICA. It may indicate an
unsafe installation.
Solutions: Contact Technical Service.
Pump blocked in
ON mode - M034
Problem description: The water may have overheated.
Switch the system off and keep away from the water.
Do not get into the minipool and prevent others from doing so.
Solutions: Contact Technical Service.
Pump blocked in
ON mode since
last use - M035
Problem description: Switch the system off and keep away from the
water. Do not get into the minipool and prevent others from doing so.
Solutions: Contact Technical Service.
* this message can be deleted from the top of the panel by pressing any key.
Alarms