Trend Sports Crusher User Manual

STEP 1: Locate both battery
compartments on the bottom
side of the Fireball pitching
machine.
STEP 2: Locate the Red and
Black battery wires inside the
battery compartment.
95 West 650 South • St. George, Utah 84770 • PH: 800-492-9334 • PH: 435-656-1756 • Fax: 435-688-0741
Unscrew the holding screw for one or both compartments.
(Each compartment holds a 4 hour battery for a total of 8 hours)
Each battery compartment will have a pair of Red and Black wires.
STEP 2: Connect the Red wire
to the "RED Colored" battery
post and the Black wire to the
"BLACK Colored" battery post.
Place the battery back into
the compartment, replace the
cover, and tighten the holding
screw.
The Crusher will run on either one battery or both batteries.
WARNING: Disconnect the power to the Crusher Pitching Machine while
installing batteries! Failure to do so may result in bodily injury.
Battery Installation Instructions
For Machines With Bottom Access Panels

Trend Sports Crusher Specifications

General

Brand	Trend Sports
Model	Crusher
Category	Accessories
Language	English

Summary

Crusher Battery Installation Instructions

Safety Precaution: Disconnect Power

Disconnect the pitching machine's power before installing batteries to avoid injury.

Step 1: Locate Battery Compartments

Find battery compartments on the machine's bottom side and unscrew the holding screw.

Step 2: Connect Wires and Install Battery

Connect red/black wires to battery posts, then replace battery and secure compartment.

Crusher Battery Installation for Non-Bottom Access Panels

Safety Precaution: Disconnect Power

Disconnect the pitching machine's power before installing batteries to avoid injury.

Step 2: Remove Ball Feeder/Hopper

Use a screwdriver to remove six screws and separate the ball feeder/hopper from the housing.

Step 3: Disconnect Power Cable

Carefully disconnect the ball feeder/hopper power cable from the circuit board inside the housing.

Step 4: Locate Battery Wires

Identify the four battery wires, noting two red and two black wire connectors.

Step 5: Connect Battery Wires

Connect red wires to red battery prongs and black wires to black prongs, avoiding contact.

Step 6: Install Batteries and Reassemble

Place batteries, reconnect power cable, reattach hopper, and tighten screws.