FCC Statement:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
Check if Connected
The green–checked icon ahead is the
Wireless Router/AP which the Wireless
Extender is working to.
WPS button behavior:
Less than 2 sec → N/A, WPS LED no blinking.
More than 2 sec → Do WPS, WPS LED start blinking
Reset button behavior:
Less than 2 sec → N/A, D5-D1 LEDs no blinking.
2-5 seconds → Do REBOOT, D5-D1 LEDs fast blinking.
More than 5 sec→ Do Factory Default, D5-D1 LEDs
blinking slowly.
Hardware Button Behavior
To Next Page
Loading...
Need help?
General
