Trevi XR 8A12 - Charge the Device

XR 8A12
English
CHARGE THE DEVICE
The diffuser must be recharged when switched off.
1. Using the supplied cable, connect the side with the C-type socket to the socket (3)
of the
speaker and the other end to the USB port of a USB power supply (5V not
included);
2. The Led indicator (1) will turn on (red) to indicate the recharging function.
When fully charged, it will turn off.
Note: when the battery is running low, the device will emit a beep a few times before turning
off automatically.
BASIC OPERATION
To turn the speaker on or off, use the On/Off switch (2).
VOLUME ADJUSTMENT
Adjust the volume via your smartphone or on the device where the song is playing.
BLUETOOTH OPERATION
Pairing to devices:
1. Place the speaker close to the Bluetooth device to pair;
2. Turn on the device and select the Bluetooth function;
3. Follow the instructions of your external device to search for the speaker;
4. Search and pair the speaker named “XR 8A12”;
5.Oncepairingissuccessful(youwillhearaconrmationtone)itwillbepossible
play music tracks.
Note:
- The Bluetooth speaker only works with one connection at a time, the
connection cannot be interrupted during normal operation.
- When Bluetooth pairing with external devices fails, delete another one
Bluetooth device in the connection list; restart the Bluetooth speaker and search for signal again.
1. Led Indicator:
Blue: playing music
Red: while charging, turns off when
charging is completed.
2. On/Off switch
3. C-Type charging socket
1
3
2
CONTROLS