38
Proper battery care will help ensure maximum life from your rechargeable receiver batteries. When your receiver batteries do
need to be replaced, you can replace them yourself with a convenient battery pack obtained from Tri-Tronics. Follow the instruc-
tions included with the new battery pack.
• Check contact points regularly for tightness, dirt or damage.
• If the receiver has been used in saltwater or brackish water clean it with clean drinking water.
• If the receiver charging contacts are dirty then clean them prior to charging.
• Wipe transmitter charging adaptor connections with a dry, clean cloth.
• For best battery life, do not store your remote trainer in very warm areas such as the dashboard of a closed vehicle.
• For best battery performance avoid transporting or storing your Remote Trainer in extremely cold areas.
• Please note that the charging cradles are not designed to get wet.
Modern microprocessor technology virtually eliminates the possibility that your unit could be unintentionally set off by someone
else with a Tri-Tronics product. Please contact our Customer Service Department at support@tritronics.com or 1-800-456-4343
with any questions.
The manufacturing of Tri-Tronics remote trainers involves exacting production methods, precise tuning, and stringent quality control
tests. In addition, these products are manufactured to operate within Federal Communication Commission (FCC) specications. It
is a violation of FCC rules to modify your equipment. Tri-Tronics veries its products to operate under Part 95 of FCC regulations.
Unauthorized modications to your equipment could result in its not meeting specications and thus violating FCC regulations. Any
and all adjustments should be performed only by technically qualied personnel authorized by Tri-Tronics. To continue to meet FCC
operating specications, any replacement of circuit components including antennas must meet Tri-Tronics’ manufacturing speci-
cations. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
To Next Page
Loading...
