Triax IFA288 - Page 7

7
The ampliers have two different adjustment options via 3-click switches:
Tilt/Slope:  (basic conguration = 0dB), 6 and 12dB amplies the
higher channel numbers more than lower channel numbers. Use this for
the higher channels if you have poor quality.
Attenuator:  (basic conguration = 6dB), 0 and 12 dB turn the signal
strength UP or DOWN, respectively. Use this if the signal is poor on all
channels.
Adjustment
 
The Power
Only once all of the antenna cables are connected at both ends can you
connect the amplier’s (and a possible cable modem’s) power
cable to the AC outlet, and turn on the power. A green light 
will show the amplier is working


Place the white lid over the amplier. Your TV amplier installation is now
complete.You can watch TV and listen to the radio via the connected
devices, subject to the signal your cable TV/communal antenna supplier
or private antenna delivers. If the appliances have never previously been
in operation, you will need to conduct a channel scan rst to get the
available radio and television channels.
Conclusion
If after installation you experience problems which can be attributed to
the amplier, please check the installation instructions on the previous
page (or TRIAX’s website) have been followed correctly.
If the problem persists, please contact an authorised TRIAX dealer who
will be able to guide you through the installation, at your own cost. If it
is assessed the product is defective, the general rules of the guarantee
and warranty will be applicable. In this instance, you should , always send
your enquiry to the store from which you purchased the product.
Service
Your IFA 284/288 is subject to the WEEE and RoHS EU directives and must
be disposed of via authorised recycling centres which provide the disposal
units for e-waste or other authorised electronic return organisations.
Disposal
EN
Mounting instruction
TRIAX IFA 284/288
distribution ampliers