Tribe EZ-Pilot Farmall 75C

Need help?

Do you have a question about the Tribe EZ-Pilot Farmall 75C and is the answer not in the manual?

Summary

Safety Information

Warnings

Describes potential hazards and precautions during installation.

Cautions

Details potential hazards and precautions for safe operation and maintenance.

Introduction

Technical Assistance

How to contact Trimble technical support for assistance.

Required Components

Hardware Organization

Illustrates the arrangement and identification of hardware components.

EZ-Pilot System Installation

Preparing the Vehicle

Steps to prepare the tractor before starting the installation.

Removing the Steering Wheel

Instructions for safely removing the existing steering wheel.

Installing the Anti-Rotation Bracket

Guides on mounting the anti-rotation bracket to the steering column.

Modifying the Plastic Cover

Instructions for modifying the vehicle's plastic cover for component fitment.

Reassembling the Steering Column

Steps to reassemble the steering column after component installation.

Assembling the SAM-200 EZ-Pilot Drive Motor

Steps for assembling the EZ-Pilot drive motor unit.

Installing the SAM-200 EZ-Pilot Drive Motor

Guides on mounting the assembled drive motor onto the steering shaft.

Installing the Trimble Steering Wheel

Instructions for installing the new Trimble steering wheel.

Removing the SAM-200 Motor

Procedures for detaching the SAM-200 motor from the steering shaft.

IMD-600 Unit Installation

Preparing the IMD-600 Unit for Installation

Steps to prepare the IMD-600 unit before mounting.

Mounting the IMD-600 Unit in the Cab

Guidance on selecting a suitable location and mounting the IMD-600 unit inside the cab.

Display Connections

FmX Integrated Display

Wiring diagram and component list for FmX display.

CFX-750 Display

Wiring diagram and component list for CFX-750 display.

Connecting the EZ-Pilot System

Instructions on connecting the EZ-Pilot system power cable to the vehicle battery.

Connecting the Sonalert Device

Details on connecting the Sonalert device for audio alerts.

Installing the Emergency Stop Switch

Guide to installing the emergency stop switch in the vehicle cab.

Installing the GNSS Antenna and Mounting Plate

Instructions for mounting the GNSS antenna and its plate on the vehicle roof.

Installing the RTK Radio Antenna

Steps to install the RTK radio antenna on the vehicle roof.

Remote Engage

Installing the Remote Engage Switch

Wiring diagram for installing the remote engage switch.

Setting up the CFX-750 Display

Configuration steps for the CFX-750 display to enable remote engage functionality.

Setting up the FmX Integrated Display

Configuration steps for the FmX display to enable remote engage functionality.

Final Machine Check

Performing the Final Machine Check

Procedures for verifying the system after installation.

EZ-Pilot Calibration Tips

Advice and best practices for calibrating the EZ-Pilot system for optimal performance.

Front Wheel Steer Tractor Calibration

Calibration values specific to front wheel steer tractors.

Advanced Parameters

Configuration settings for advanced system parameters.

Vehicle Measurements

Case IH Tractor Measurements

Physical dimensions for Case IH tractor models like Farmall.

New Holland Tractor Measurements

Physical dimensions for New Holland tractor models like T4 and T5.