Tricity Bendix WDR 1040 W

Questions and Answers

R
rosswilliamJul 29, 2025
What to do if my Tricity Bendix WDR 1040 W Washer/Dryer won't empty and/or spin?
- C
  cervantesrandyJul 29, 2025
  If your Tricity Bendix Washer/Dryer is not emptying or spinning, here are a few things to investigate: 1. Check if the drain hose is squashed or kinked. 2. Make sure you've selected a program that ends with the water being drained from the tub. 3. Inspect the drain filter for blockages. 4. Verify that the drain hose extension, if you're using one, is correct. 5. See if the drainage system pipes are blocked. 6. Redistribute the clothes inside the drum to allow the machine to spin.
J
Jessica LyonsAug 2, 2025
Why won't my Tricity Bendix WDR 1040 W Washer/Dryer start?
- L
  Lauren BrownAug 2, 2025
  If your Tricity Bendix Washer/Dryer isn't starting, there are several things you can check: * Make sure the door is fully closed. * Ensure the plug is correctly inserted into the power socket. * Verify that the socket has power. * Inspect the main fuse and the fuse in the plug to see if either has blown. * Confirm the selector dial is in the correct position. * Press the ON/OFF button.
N
Natalie MosleyAug 6, 2025
Why is there water on the floor near my Tricity Bendix WDR 1040 W?
- N
  Nicholas SmithAug 6, 2025
  If you find water on the floor around your Tricity Bendix Washer/Dryer, consider the following possible causes: * Too much or unsuitable detergent might have been used, creating excessive foam. * One of the inlet hose fittings may be leaking. * The drain hose could be damaged or not securely positioned. * The detergent dispenser drawer or its recess may be clogged. * The drainage system pipes might be blocked.
T
tkennedyAug 10, 2025
How to stop my Tricity Bendix Washer/Dryer from vibrating when spinning?
- S
  Sarah MaldonadoAug 11, 2025
  If your Tricity Bendix Washer/Dryer vibrates excessively during spinning, consider these possibilities: * Ensure the internal packing has been removed. * Check that the machine isn't touching the wall or any furniture. * Confirm the machine is stable and level (check diagonally). * See if the washing load is unevenly distributed in the drum. * Make sure there isn't too little laundry in the drum.
C
Charles SmithAug 15, 2025
What to do if my Tricity Bendix Washer/Dryer is not filling with water?
- C
  Catherine TurnerAug 15, 2025
  If your Tricity Bendix Washer/Dryer isn't filling with water, try the following: * Make sure the water tap is fully open. * Check the filters in the inlet hose for any blockages. * Ensure the inlet hose isn't squashed or kinked. * Verify that the door is completely closed.
J
John HallAug 19, 2025
Why are the washing results from my Tricity Bendix WDR 1040 W Washer/Dryer unsatisfactory?
- M
  Micheal SextonSep 12, 2025
  If you're not getting the washing results you expect from your Tricity Bendix Washer/Dryer, consider the following: * You may not be using enough detergent or the detergent may be unsuitable. * Stubborn stains should be pre-treated before washing. * Ensure you've selected the correct wash program for the load. * Avoid overloading the drum with too much laundry.
J
Jennifer HarmonAug 23, 2025
Why does my Tricity Bendix WDR 1040 W Washer/Dryer fill then empty right away?
- A
  Andrea TuckerAug 23, 2025
  If your Tricity Bendix Washer/Dryer fills with water and then empties immediately, check these things: * The end of the drain hose might be too low. * The end of the drain hose might be submerged in water. * There might not be a vent in the end of the drain hose.