TRICKSTUFF® GMBH
SCHWABENMATTEN 17A
79292 PFAFFENWEILER
GERMANY
TECH-SUPPORT@TRICKSTUFF.DE SERVICE MANUAL – DIRETTISSIMA/MAXIMA PUMP V2024_02. PAGE 16 OF 27
7. Lastly, remove the bleed bolt using a TX10 key. Dispose of the old O-ring and put a new one
on.
8. Clean pump housing and reservoir cap with warm water and a liberal amount of washing-up
liquid. Works best in combination with a soft brush and a lot of clean water for rinsing
afterwards. Before assembly, make sure everything is properly dried and no water residue
remains. You can dry the pump with compressed air or by putting it on a household radiator
for some time.
9. Use a flashlight to check the cylinder surface for cleanliness, scratches and possible
damage/debris. If you find your cylinder surface damaged, please contact the Trickstuff-
Support.