Trilliant SecureMesh RES-3000- Focus User Manual

RES-3000-Focus
PA-0129A Rev. 1.0
June 18, 2010 Page 1 of 4
RES-3000-FocusAX
Introduction
This document will help the SecureMesh user to retrofit the product model RES-3000-
Focus/FocusAX in a Landis &Gyr Focus® meter as intended.
Safety and Assembly Cautions
- Warning: The meter carries lethal voltages. The meter must be completely
disconnected from any external circuits. Failure to observe this practice can result in
serious injury or death.
- Caution: These devices are electrostatic sensitive. It is best to use a grounded
electrostatic mat and wrist strap to prevent electrostatic discharge.
- Important: It is not necessary to completely separate the top of the meter from the base
of the meter for this retrofit procedure. However, if the two parts are completely
disconnected and separated, it is extremely important to keep each meter component
together for re-assembly. This is due to the top section of the meter containing
calibration “characterization” programming for the CTs in the meter base. If these
components get mixed up with other meter components, current measurement errors will
occur.
Material
• Focus meter (must be AMR configured)
• Trilliant SecureMesh RES-3000-
Focus/FocusAX .
• Mounting Screws - QTY=3 (provided by
L&G,
ref.Trilliant # HS-0029B & HS-0029C)
• Self-Retaining Spacers-QTY=3
(provided by L&G, ref. Trilliant # HE-
0033C & HE-0033D)
• Serial # & FCC/IC label (provided by
L&G, ref Trilliant #.: HI-0307A)
SecureMesh retrofit for Focus/FocusAX meter

Trilliant SecureMesh RES-3000- Focus Specifications

General

Brand	Trilliant
Model	SecureMesh RES-3000- Focus
Category	Measuring Instruments
Language	English

Summary

SecureMesh Retrofit Procedure

Introduction

Provides an overview of the document's purpose for SecureMesh user retrofit.

Safety and Assembly Cautions

Details critical safety warnings for handling lethal voltages and electrostatic discharge.

Material Requirements

Lists all required components for the SecureMesh retrofit procedure.

Assembly Procedure Steps

Disassemble Meter Components

Instructions to disassemble the meter cover and base to access internal connectors.

Prepare SecureMesh Board

Steps to snap plastic spacers onto the SecureMesh PCB, cautioning against damage.

Connect SecureMesh Board

Guides the connection of the SecureMesh board's female connector to the meter's male connector.

Secure SecureMesh Board

Attaches the SecureMesh PCB using mounting screws into the plastic spacers.

Finalize Meter Assembly and Testing

Affix labels, reassemble the meter top, affix cover, and perform functional test.

SecureMesh Radio Specifications and Compliance

Radio Specifications

Details technical specifications for the SecureMesh radio, including IEEE standard and output power.

FCC and Industry Canada Compliance

States compliance with FCC Part 15 and IC regulations, including warnings.

RF Exposure Compliance

Outlines RF exposure limits and antenna installation requirements for compliance.