Trimble Juno T41 - Page 70

Juno T41
User Manual
58
NOTE: The Image Tagging of date-time and GPS on the image is not
compatible with a Digital Zoom setting other than 1.0x. The EXIF tagging
is not affected by Digital Zoom.
Brightness ( )
A tap on the Brightness icon enables adjustment of the Brightness offset.
 +3 [Maximum Brightness]
 +2
 +1
 0 [Normal Brightness]
 -1
 -2
 -3 [Minimum Brightness]
Selection of any option applies that setting to camera preview and to
images captured. Increase the Brightness if the subject is underexposed,
or decrease the Brightness if the subject is overexposed. A common
situation requiring adjustment to Brightness is capturing a scene with
high contrast caused by direct exposure of light sources or areas of
shading or shadows.
Flash Settings ( )
A tap on the Flash Settings icon displays the following options.
 On: Selection of this option enable the flash icon ( ) on the
screen and dual LEDs will flash while capturing images.
 Off: Selection of this option disables the LED flash.
 Auto: Selection of this option enable the LEDs to flash if
needed to illuminate the scenes with low-light. The auto flash
icon ( ) will display on the screen.
Image Quality ( )
A tap on the Image Quality icon displays the following options.
 Economy: Select this option should save the captured image
with low quality (high compression).
 Normal: Select this option should save the captured image
with medium quality (medium compression).