>2('!76/%
!</*%E7217.%
YX!
6.7 Working with GPS
73;! ! b!"/::+2J<!b!"K<:/,!b!"K<:/,%'2H3*,7:+32!b!;+*/./<<!B'!%##!&:!
4'2$!?#-&<#!83%!UIM!&(%B3@@#?*!LEO5!&%!B8#!?#?&<3B#?!83$?D3$#!;'$B!:'$!
B8#!12&@B_&(!UIM!dLEO/!&%!?#?&<3B#?!B'!B8#!#WB#$(3@!^_;&(e*!
78#!UIM!&%!<'A;3B&1@#!D&B8!3;;@&<3B&'(%!B83B!3<<#;B!B8#!FOJ.!;'%&B&'(!
&(:'$A3B&'(!2%&(=!3!?#:32@B!132?!$3B#!':!)]6++*!
GPS settings:
N:!4'2!3$#!2%&(=!'(@4!'(#!UIM_3D3$#!3;;@&<3B&'(V!B8#%#!%#BB&(=%!?'!('B!
(##?!B'!1#!<83(=#?*!S'D#-#$V!B'!2%#!A2@B&;@#!UIM_3D3$#!3;;@&<3B&'(%V!
B3;! ! b!"/::+2J<!b!"K<:/,!b!&F"!3(?!%#@#<B!B8#!:'@@'D&(=!B31%a!
Access: The GPS Intermediate Driver (GPSID) allows
multiple applications to access the GPS receiver. If the check
box is unchecked, the GPSID is disabled.
Hardware: COM2 is the hardware port dedicated for the
built-in GPS. Verify that COM2 is selected. The internal GPS
communicates at 38400 baud by default. If it has been
modified by a third-party program, adjust to match the
receiver baud rate.
Programs: Programs that use GPS need to know which COM
port to use to access GPS data. When using more than one
GPS-aware application, the same GPSID port must be used
in each application. Ensure that the COM port on the
GPS-aware application(s) is set to the same GPSID port as
shown in the Programs tab of the GPS applet. The program
port must be a different port than the hardware port. By
default, the GPS program port is COM3 and should not be
modified unless directed by Technical Support.
AB)#C!M'A#!UIM_3D3$#!3;;@&<3B&'(%!A34!('B!<'AA2(&<3B#!'-#$!UIM!
;$'=$3A!;'$B%*!
Exiting GPS applications
.(4!B&A#!4'2!#W&B!3!UIM!3;;@&<3B&'(!d%2<8!3%!M3B"&#D#$e!&B!&%!3?-&%31@#!B'!
To Next Page
Loading...
