Trimble R10 - NMEA Encryption; Network Configuration menu; Network Configuration (Summary)

TrimbleR10ReceiverWebHelp
NMEAEncryption
Thisisnotsupported.
NetworkConfigurationmenu
NetworkConfiguration(Summary)
ThesesettingsdisplaythecurrentreceiverInternetconfiguration.
DHCPStatus–IndicatesifDHCPisonoroff.IfDHCPison,thereceiverisautomaticallyassignedan
IPaddressfromthenetwork.
ThereceivercanrecoveritsIPaddresswheninDHCPmodewheneveritisconnectedtoaDHCP

serverthatistemporarilyunavailable.IfthereceiverisconnectedtoaDHCPserverwhichisthen
notavailableandits“lease”hasexpired,thereceiverswitchestoIPaddress169.254.1.XXX.Every
60seconds,thereceivertriestoreconnecttotheDHCPservertoobtainanewIPaddress.This
is
usefulwhenthereceiver“dropsoff”theDHCPserveranddoesnotrequireamanualpowercycle.
EthernetIP–DisplaysthecurrentEthernetIPaddressofthereceiver.
DNSAddress–DisplaystheIPaddressofthecurrentDomainNameServer.
SecondaryDNSAddress–DisplaystheIPaddress
oftheSecondaryDomainNameServer
FTPPush–IndicatesifFTPPushisonoroff.
HTTPServerPort–Displaystheportonwhichthewebserveriscurrentlyrunning.Thedefault
HTTPportis80.
NetworkAddressTranslation–DisplayswhetherNATisEnabledorDisabled.

If
PPPisenabled,thefollowinginformationisdisplayed:
PPPPort–DisplaystheportonwhichthePPPconnectionisestablished.
PPPState–IndicatesifaPPPconnectioniscurrentlyestablished.
PPPLocalAddress–DisplaystheIPaddressofthereceiveronthePPPconnection.
PPPRemoteAddress
–DisplaystheIPaddressofthedevicethatthereceiverisconnectedtoon
thePPPconnection.Thereceiverassignsthisaddresstotheconnectingdeviceonco nnection.

IfDataLoggingandFTPPusharebot henabled,thefollowinginformationisdisplayed:
FTPPushServer–Displaystheserveraddress
thatfileswillbepushedto.
EthernetConfiguration
UsethesesettingstochangetheEthernetconfigurationofthereceiver.
IPSetup–SetthereceivertoobtainanIPaddressusingDHCP(DynamicHostConfiguration
Protocol)oraStaticIP.