Trimble R10 - PPP Configuration

TrimbleR10ReceiverWebHelp
TheDNSaddresswillbechangedaccordinglywhenthedefaultinterfaceischanged.Forexample,
whenusingPPPoverinternal/externalGPRSmodem,thedefaultinterfaceissettoPPPoverGPRS
modem,andthePPPserverwillassignitsspecialDNSaddresstotheconnection.Thesystem
will
obtainaDNSaddressfromthePPPconnectionunlessitis“forced”.WhenPPPisdisconnected,the
DNSaddresswillbechangedbacktotheEthernetDNSaddress.ThepriorityofDNSaddressesand
defaultrouteis:
1. PPPoverGPRSconnection.
2. Ethernet.
3. OtherPPPs.
4. Wi‐
Ficonnection.
DNSAddress–DisplaysthecurrentDNSaddress.
SecondaryDNSAddress–DisplaysthesecondaryDNSaddress.
ForceDNSAddress–Whenyouselectthischeckbox,youcanenteraspecificDNSServerIP
addressandDNSDomainName.AfteryouclickChangeConfiguration,thisDNSIP
addressandDNS
DomainNameisusedinthesystem.Ifthischeckboxisselected,thesystemusesthesuppliedDNS
addressandignoresanyDNSaddressassignedbyanDHCPserverorPPPserver.Whetheryouhave
EthernetorPPP,theDNSIPaddressisforced.
DNSAddress–
EntertheDNS(DomainNameServer)addressforthenetworkthatthereceiverwill
connectto.ThisfieldcannotbeeditedwhenusingDHCP.InDHCPmode,theDNSAddressissentto
thereceiverandisuniqueforeachcustomer'sLAN.IfyourequireastaticIPsetup,this
DNSaddress
willhavetobeobtainedbyansystemadministrator.
SecDNSAddr–EntertheSecondaryDNS(DomainNameServer)addressforthenetworkthatthe
receiverwillconnectto.
DNSDomain–EntertheDNSdomainforthenetworkthatthereceiverwillconnectto.Thisfield
cannot
beeditedwhenusingDHCP.TheDNSDomainnamealsocomesfromtheDHCPserverandis
mainlyusedbymDNSandUPnP.
ChangeConfiguration–Whenthisispressedthesenewsettingswillbeappliedforthestatic
configuration.Anystaticsettingswillbeoverwrittenifthesystem
goestofactorydefaults(DHCP).
If“ForceDNSAddress”isnotselectedand“ChangeConfiguration”ispressed,thentheprovided
DNSwillbesettothesystemonce,butitwillnotbeforcedandintheDHCPcasethenextDHCP
renewwilloverwritetheDNSaddressesthatyoujust
set.
PPPConfiguration
UsethesesettingstochangethereceiverPPP(Point‐to‐PointProtocol)configuration,whichisused
tomakeInternetconnectionsthroughBluetoothwirelesstechnologyorawiredserialconnection.
Port–IndicateswhichreceiverportthePPPconnectionistobeestablishedon.
State–IndicatesifaPPPconnectionis
currentlyconnected.
AutoRestart–Selectthischeckboxtohavethereceiverautomaticallyre‐establishthePPP
connectionifitisdropped.