Trimble R10 - Save; Connect; Routing Table Configuration

TrimbleR10ReceiverWebHelp
VerifyPassword–Re‐enterthepassword(ifrequired).
Seeadvancedsettings–Selectthischeckboxtoviewandchangeadvancedsettings.
DefaultLocalAddress–EntertheIPaddressthatisassignedtothereceiverwhenaPPPconnection
isestablished.
DefaultRemoteAddress–
EntertheIPaddressthatisassignedtotheremotedevicewhenaPPP
connectionisestablished.
DNSAddress–EnterthedefaultDNSIPAddress.
RefusePAP–Bydefault,thischeckboxisnotselected.Ifitisselected,noPAP(Password
AuthenticationProtocol)isenforcedinthe
system.
RefuseCHAP–Bydefault,thischeckboxisnotselected.Ifitisselected,thesystemdoesnotuse
CHAP(ChallengeHandshakeAuthenticationProtocol).
EnableACCMnegotiation–ACCM(AsynchronousControlCharacterMap)isoneoftheLCP‐
negotiatedoptionswithintheCONFREQframe.ACCMsetsthecharacterescape
sequences,which
tellstheporttoignorespecifiedcontrolcharacterswithinthedatastream.Iftherouteratthe
otherendoftheconnectiondoesnotsupportACCMnegotiation,theportisforcedtouse
FFFFFFFF.Bydefault,thischeckboxisselected.
EnableACCMconfiguration–ACCMConfigurationis
oneofoptionsinPPPLCPlayer,andallows
LCPConfigure‐AcktodoACCMmapping.Bydefault,thischeckboxisnotselected.
Maxidletime[minutes]–ThePPPconnectionisdroppedafterthislengthofidletime.
Maxconnecttime[minutes]–ThePPPconnectionisdroppedafter
thisamountofconnection
time.Ifitissetto0,themaximumconnectiontimeisnotlimited.Thatis,thereisaninfinite
connectiontime.
CPIN–SIMPIN(PersonalIdentificationNumber).TheGSM/GPRSModemhasaSIMcard.Forsome
Europeancountries,beforedialing,aPINisrequired
forthemodem.TheCPINhasavalueof4to8
digits,ifrequired.IfausertriestomakeaPPPconnectionbeforetheSIMPINcodeisconfirmed,it
refusesthe“ATD”commandwithanerror.However,afterthreeunsuccessfulattemptstoenterthe
PIN,thePUK(Personal
UnblockingKey)isrequiredtoforcetheusertoenteranewPINcode.
VerifyCPIN –Re‐entertheSIMPINcodeto verifythedigitsenteredintheCPINfield.
Save–Savestheconfigurationintothereceiver'sApplicationFile(Appfile)withoutattemptingto
makeaPPPconnection.
Connect–StartsthePPPconnectionbasedontheaboveconfigurationandsavesanychangesto
thereceiver'sAppfile.
Disconnect–DisconnectsanyPPPconnection.
GoBackToDefaults–Setstheportconfigurationtoitsdefaultsettings.
RoutingTableConfiguration
Usesthesesettingstoconnecttoasub‐network,suchasbehindagateway,ortoaddstaticroutes
toanetwork.Thispageisforadvancedusers.