Trimble R10 - Receiver Status menu

TrimbleR10ReceiverWebHelp
 AppleSafari

Thefollowingconfigurationmenusareava ilable.
ReceiverStatusmenu
TheReceiverStatusmenuprovidesaquicklinktoreviewthereceiver’savailableoptions,current
firmwarever sion,IPaddress,temperature,runtime,satellitestracked,currentoutputs,available
memory,positioninformation,andmore.
Satellitesmenu
UsetheSatellitesmenutoviewsatellitetrackingdetailsandenable/disableGPS,GLONASS,and
SBASsatellites.
{b}Note–{/b}ToconfigurethereceiverforOmniSTAR,usetheOmniSTARmenu.
DataLoggingmenu
UsetheDataLoggingmenutosetupthereceivertologstaticGNSSdata.Thismenuisavailable
onlyifthereceiverhastheDataLoggingoptionenabled.Youcanalsoconfiguresettingssuchas
observablerate,positionrate,continuouslogging,continuousloggingrate,andwhethertoauto
deleteold
filesifmemoryislow.
ReceiverConfigurationmenu
UsetheReceiverConfigurationmenutoconfiguresuchsettingsaselevationmaskandPDOPmask,
theantennatypeandheight,thereferencestationposition,andthereferencestationnameand
code.
I/OConfigurationmenu
UsetheI/OConfigurationmenutosetupalloutputsofthereceiver.Dependingonthereceiver's
specificationitmayoutputCMR,RTCM,RTCM‐REPEAT,RT17/RT27,NMEA,GSOF,orBINEX
messagesonavarietyofportsincludingTCP/IP,NTRIP,UDP,serial,.
Bluetoothmenu
UsetheBluetoothmenutoconfigurethereceivertoconnecttootherdevicesthatuseBluetooth
wirelesstechnology.Thesedevicescanbeusedtoconfigurethereceiver,andgenerateorreceive
corrections.
ThefollowingTrimbledevicescanbeconnectedtothereceiverusingBluetoothwireless
technology:
 TSC3controller