Restore Defaults:
When connected to your unit’s GPS receiver: Tapping the Restore
Defaults tab will result in the following settings being changed:
• GPS receiver output set to NMEA mode
• GPS status voice prompt - OFF
• Static Navigation - OFF
• Smooth Tracking - OFF
• Under Advanced
NMEA message settings are as follows:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG – 1 sec
o GSV – 1 sec
o RMC – 1 sec
• DGPS settings under the DGPS tab are set back to their defaults
of Usage: Auto, Type: SBAS ON and SBAS Sat. PRN: Auto
• No change to any COM settings
Each of the above settings (except for the GPS status voice
prompt) are sent and applied to your unit’s GPS receiver.
When disconnected from your unit’s GPS receiver: Tapping the
Restore Defaults tab will result in the following settings:
• GPS receiver output set to NMEA mode
• GPS status voice prompt - OFF
• Static Navigation - OFF
• Smooth Tracking - OFF
• Under Advanced
NMEA message settings are as follows:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG – 1 sec
o GSV – 1 sec
o RMC – 1 sec
To Next Page
Loading...