5-8 Using BIOS Setup and System Utility
When to Use BIOS Setup Utility
You need to run BIOS Setup utility when:
You see an error message on the screen requesting that you to run
BIOS Setup utility.
You want to restore the factory default BIOS settings.
You want to modify some specific hardware settings.
You want to modify some specific settings to optimize the system
performance.
Starting BIOS Setup Utility
NOTE:
The BIOS Setup Utility screens shown in this chapter are for your reference only.
The actual items or settings on your tablet computer may differ.
The settings you select in your operating system might override similar settings in
BIOS Setup Utility.
To run BIOS Setup Utility, press the Enter button when the prompt
appears on the screen during system startup. The prompt shows up on the
screen for only a few seconds. You must press the Enter button quickly. A
small window appears, select Launch System Setup (by pressing the
Directional Button) and then press Enter button again. The BIOS Setup
Utility main screen appears as shown next.
To Next Page
Loading...