GPS info of path tracking is being
recorded into KML file.
This message appears when the KML file is
recording.
Saving KML file, please wait …
This message will appear when the user quits the
program, and the KML file is being saved.
Virtual-GPS program was not
detected. Please check if
Virtual-GPS program was
installed properly.
When tapping the Virtual-GPS button and the
software is not detected, this message will
appear.
Unable to start the Virtual-GPS
service. Please try again.
Virtual-GPS service should automatically start
when system starts. If not, it may need to reboot
again.
Unable to open the GPS device.
Please check the GPS device
status.
The Virtual-GPS application will automatically
scan the real GPS COM port. If the real COM
port is occupied, does not exit, or connection
failed, this message will appear.
Virtual-GPS is unable to create
more than 16 virtual COM ports.
The Virtual-GPS application only allows the user
to create 16 virtual COM ports. When the user
adds the 17th COM port, this message will
appear.
Unable to remove it because this
COM port is being used by
another GPS application.
When the COM port is occupied by another GPS
application and the user tries to remove the COM
port, this message will appear.
Unable to execute the
Virtual-GPS program because file
may be lost. Please re-install
Virtual-GPS program again.
If the Virtual-GPS software is not functioning
properly or not found, this message will appear.
To Next Page
Loading...