Triner Scale TS-700 Series - TS-700 SS Quick Setup

Calibration & Connectivity | TS-700 Series
5
TS-700 SS
The 3-wire terminal block located on the main
board can be utilized to connect the indicator to
a peripheral device such as a printer or remote
display, or to interface the indicator with a PC.
NOTE: PC interface requires Triner DataLog
PC™ software to be installed on the PC.
TS-700 SS RS-232 Terminal Block
TS-700 WB
The RS232 3-pin quick-connect serial port can
be utilized to connect the indicator to a
peripheral device such as a printer or remote
display, or to interface the indicator with a PC.
NOTE: PC interface requires Triner DataLog
PC™ software to be installed on the PC.