ASSEMBLY INSTRUCTIONS
STEP 1
For easiest assembly, do not attach TOP POLES (B) and
BOTTOM POLES (A) until instructed. Once connected, these
will be posts for the rack.
Note that POLES (A+B) have slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (D) has raised
horizontal lines inside designed to lock them in place on
POLES (A+B).
On BOTTOM POLE (A), place one pair of SLIP SLEEVES (D) at
desired height no higher than 3rd indentation from bottom.
Please make sure arrow faces up and word “TOP” is right side
up.
Slide pair of SLIP SLEEVES (D) until you hear a click to confirm
the pair is locked onto BOTTOM POLE (A). Do this for each
BOTTOM POLE (A) and make sure height is identical for each
BOTTOM POLE (A). Do NOT place more than one pair on each
pole at a time.
A
D
Note: There will be a very small gap in-between two locked SLIP SLEEVES (D)—this is normal.
STEP 2
Place SHELF (C) on its side and slide each
BOTTOM POLE (A) through each corner
cylinder on SHELF (C). Make sure SHELF (C)
corner cylinders are positioned over SLIP
SLEEVES (D).
Stand the unit upright.
Note:
• Level side of SHELF (C) is TOP side
(TRINITY logo on corner cylinders should
be right-side up.)
• Use a rubber mallet, if needed, to secure
SHELF (C).
C
A
© 2021 TRINITY - 800.985.5506
2
To Next Page
Loading...
