ASSEMBLY INSTRUCTIONS
STEP 3
On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES
(D) at desired height. Make sure arrow faces up and
word “TOP” is right side up. Do this for each
BOTTOM POLE (A), and make sure height is identical
for each BOTTOM POLE (A).
Lower SHELF (C) over each BOTTOM POLE (A) so
corner cylinders of SHELF (C) are positioned over SLIP
SLEEVES (D).
Note: Use a rubber mallet, if needed, to secure SHELF
(C).
C
STEP 4
Screw TOP POLE (B) into BOTTOM POLE (A).
Repeat for each remaining TOP POLE (B).
Note: The top of each TOP POLE (B) is
indicated by a BLACK END CAP.
A
B
3
© 2021 TRINITY - 800.985.5506
To Next Page
Loading...
