Press Method.
Step 2.
Lock Filter Housing onto Brew Chamber
Tips:
(a) Align lugs on Filter Housing to gaps in Brew Chamber.
(b) Raise, and then turn to the right until Filter Housing is locked into position.
(c) If desired, pre-heat the Brew Chamber by pouring in boiling water. Ensure Flow Controller is
“off” (refer page 14) if pre-heating, then turn the Flow Controller to “on” after 60 seconds and
drain hot water into a cup or decanter that has been positioned below Flow Controller spouts.
(d) The Flow Controller provides good heat retention for brewing once pre-heated. Beware of hot
surfaces on the stainless steel, and handle only the silicone surfaces when turning the
Flow Controller.
(a) (b)
To Next Page
Loading...
