ASSEMBLY INSTRUCTIONS
Place HANDLE SCREW (H) through hole
in the HANDLE LEG (D) and tighten it
with SCREWDRIVER (I) to the nut in the
HANDLE (E).
Repeat for the other side.
Lay WOOD TOP FRAME (A) on a clean
surface to prevent scratching the top
surface. Take HANDLE LEG (D) and
orient it in the proper position by aligning
the hole for mounting the handle along
the long edge of the WOOD TOP FRAME
(A)
Place LEG SCREW (G) through hole in
WOOD TOP FRAME (A) and tighten it
with SCREWDRIVER (I) to the top nut in
HANDLE LEG (D).
Repeat for the other HANDLE LEG (D).
Please note that the HANDLE LEG (D) has a
FOOT PAD on the bottom.
© 2016 TRINITY - 800.985.5506
2
STEP 1
STEP 2
G (2) I (1)
A (1) D (2)
A
D
H (2) I (1)
E(1)
I
G
E
H
I
To Next Page
Loading...
Need help?
General
