Need help?Do you have a question about the Trio SG-402 and is the answer not in the manual?
General| Brand | Trio |
|---|---|
| Model | SG-402 |
| Category | Portable Generator |
| Language | English |
This section describes aligning IF transformers for radio receivers using the SG-402.
This section details the process of tracking receiver frequencies using the SG-402 signal generator.
Guidance on adjusting short wave receivers operating above 10MHz using the SG-402.
Procedure for safely removing the outer case of the SG-402 unit using a Phillips screwdriver.
Instructions for reattaching the SG-402 case to the chassis, including screw placement.
Detailed steps for removing the front panel of the SG-402, including knob and setscrew removal.
Procedure for calibrating the output voltage of the SG-402 using an RF voltmeter.
Method for setting the internal modulation degree to approximately 40% using an oscilloscope.
Steps to properly position the frequency dial pointer on the SG-402 scale.
Guide to calibrating the SG-402's oscillation frequency across its various ranges using a frequency counter.
To Next Page