Need help?Do you have a question about the Triplett Sniff-It 2 and is the answer not in the manual?
General| Type | Gas Leak Detector |
|---|---|
| Testing Capability | Yes |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Detectable Gases | methane, propane, butane |
| Sensor Type | Semiconductor |
| Alarm Method | LED and Audible Alarm |
Always test the Sniff-It 2 on a known AC voltage source before initial use to prevent injury.
The device may not detect AC voltage in all situations. Always use caution and good work practices.
Device may indicate voltage when none is present. Use extreme caution with high voltages.
Do not place fingers near the tip, as this can interfere with detection and cause false readings.
Turn on the device, adjust sensitivity knob, and verify initial flash/chirp for proper function.
Detection depends on distance and voltage magnitude; adjust sensitivity to 'home in' on source.
Adjust sensitivity using a known voltage source for accurate detection of similar or higher voltages.
Test outlet polarity by inserting tip into slots and observing chirp/flash rate changes.
Test bulb sockets for unexpected voltage with the light switch off and bulb removed.
To Next Page