Tripp Lite B006-DP2UA2 - Page 6

6
Installation
6
At the other end of the cables from step 5, plug the
DisplayPort cables, USB 3.0 cable, microphone cable and
speaker cable into their respective ports on the computer.
Repeat steps 5 and 6 for each dual-screen PC system you
are installing.
7
(Optional) Plug your USB peripherals into the front or rear
USB 3.1 Gen1 Peripheral Ports.
8
Plug the power adapter included with the KVM switch into
an AC power source, then plug the power adapter cable
into the switch’s Power Jack.
9
Power on the computers.