Tripp Lite B126-1A1-WP User Manual

17
Extender/Splitter with Remote/Repeater Installation
1
Make sure the HDMI source is powered OFF.
2
ConnecttheHDMIsourcetotheINPUTportontheB126-002or
B126-004usingaTrippLiteP568-SeriesHDMICable.
3
Optional for B126-004: Connect a local monitor to the LOCAL
HDMIportusingaTrippLiteP568-SeriesHDMICable.
4
Connect the external power supply to the local unit and plug it into
aTrippLiteSurgeSuppressor,PDUorUPS.ThegreenRJ45LEDs
illuminate to indicate power is being received from the external
power supply. An additional Red LED on the B126-004 also
illuminates to indicate that power is being received.
5
UsingCat5e/6cable,connectoneoftheRJ45outputportsonthe
localunittotheRJ45inputportontheB126-110remote/repeater
unit.
6
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unitusingaTrippLiteP568-SeriesHDMICable.
7
Connect the external power supply to the remote/repeater unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
powerLEDandtheGreenRJ45LEDsilluminatetoindicatetheunit
is receiving power.
Upto4unitscanbedaisy-chained(3remote/repeatersand1receiver).
Toconnectadditionalremote/repeaterunits,proceedtostep8.Tonish
your installation with a B126-1A0 or B126-1A0-WP-1 remote receiver
unit, proceed to step 12.
8
UsingCat5e/6cable,connecttheRJ45OUTPUTportontherst
remote/repeaterunittotheRJ45INPUTportonasecondremote/
repeater unit.
9
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unitthatyoujustaddedusingaTrippLiteP568-SeriesHDMICable.
201109206-93-3023-EN.indd 17 10/24/2011 10:01:23 AM

Tripp Lite B126-1A1-WP Specifications

General

Brand	Tripp Lite
Model	B126-1A1-WP
Category	Extender
Language	English