To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite T040-001-HDMI and is the answer not in the manual?
General| LED Indicators | Yes |
|---|---|
| Power Source | 9V Battery |
| Cable Types Supported | HDMI |
| Product Type | Cable Tester |
| Supported Resolutions | Up to 4K |
| Type | HDMI Tester |
| Testing Capability | Tests HDMI cables for proper pin connections |
| Certifications | RoHS Compliant |
| Tested Connectors | HDMI |
| Testing Functions | Continuity, Shorts, Crossed Wires |
| Connectors | HDMI Type A (male) |
Connect cable, switch mode (Continuity/Sweep), and observe LEDs for test results.
Confirms correct wiring when all LEDs illuminate on both Master and Remote units.
Identifies out-of-order or crossed wires by specific LED illumination patterns on Remote unit.
Detects an open circuit when corresponding LEDs on both Master and Remote units remain off.
Identifies a short circuit by Master unit LEDs illuminating brighter while Remote unit LEDs remain off.
TRIPP LITE warrants products against defects in materials and workmanship for one year from date of initial purchase.
Register your Tripp Lite product online for quicker service and a chance to win a free product.
