2
TLNETCARD is an optional network card you can install in the accessory slot of a compatible UPS system. TLNETCARD connects your Tripp Lite
device to your Ethernet network for remote monitoring, control and condition reporting. You can manage the device from an SNMP Network
Management Station, a Web browser or telnet. The TLNETCARD can also send SNMP traps or email messages to the addresses you specify,
alerting you automatically to events such as power failures.
1.1 System Requirements
• Tripp Lite UPS system with compatible accessory slot.
• Ethernet network that supports the TCP/IP protocol. Firewall ports 3664 and 3665 may need to be opened.
• One of the following options for remote monitoring and control:
• SNMP-based Network Management Station (such as HP
®
OpenView
®
)
• Web browser
• VT-100 Telnet and/or SSH Client
• For “Terminal Mode” configuration only:
• Terminal emulation software program (such as TeraTerm Pro by Ayera Technologies)
• Computer with available DB9 serial port
Warning: Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the
life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
1. Introduction
To Next Page
