Need help?Do you have a question about the TriStar 120 and is the answer not in the manual?
Details about the transmitter's power output, emission type, spurious response rejection, and modulation.
Details about the receiver's circuit type, frequency range, sensitivity, squelch, selectivity, and audio output.
Describes the dual-conversion superheterodyne receiver, its PLL operation, ANL, and adjustable squelch circuit.
Explains the transmitter's crystal-controlled operation, 5-watt power output, and modulation capabilities.
Covers the transceiver's requirement for a 12-volt DC negative ground system and fused power lead.
Details controls like mounting bracket, LED display, signal meter, switches, microphone input, volume, and squelch.
Details the HI/CB/LOW switch, lamps, channel switch, speaker jacks, antenna, and DC power cable.
Instructions for physically mounting the unit using the provided bracket and securing screws.
Guidance on connecting the transceiver to a 12-volt DC power source, emphasizing voltage and ground requirements.
Steps for operating the receiver, including channel selection, and adjusting the squelch control for optimal performance.
Guide to transmitting, microphone usage, and understanding the LED TX/RX signal meter for RF power output.
Instructions for using the transceiver as a Public Address system with an external horn-type speaker.
Information regarding transceiver testing prior to shipment and notes that further adjustments are not normally required.
A block diagram illustrating the internal functional components and signal flow of the transceiver.
General| Brand | TriStar |
|---|---|
| Model | 120 |
| Category | Two-Way Radio |
| Language | English |
To Next Page