What to do if TriStar Air Conditioner doesn’t cool enough?
If your TriStar Air Conditioner isn't cooling enough, ensure all windows and doors are closed to prevent warm air from entering. Remove any heat sources from the room. Check that the hot air exhaust hose is properly connected and not blocked. Also, make sure the temperature isn't set too high and that the air inlet is clean and unobstructed.
Why is my TriStar AC 5529 not cooling enough?
If your TriStar Air Conditioner isn't cooling enough, several factors could be the cause. First, ensure all windows and doors are closed to keep the cool air from escaping. Eliminate any heat sources within the room that may be affecting the temperature. Check the exhaust air hose to ensure it's properly connected and not blocked. Also, verify that the temperature setting isn't too high, and if it is, reset it to a cooler setting. Finally, inspect the air inlet and clean it if it's blocked.
What to do if TriStar AC 5529 Air Conditioner shows E2 code?
If your TriStar Air Conditioner displays an E2 code, it means the water tank is full. Please empty the water tank.
Why does TriStar Air Conditioner auto power-off in heating mode?
If your TriStar Air Conditioner automatically powers off in heating mode, it's likely due to heating protection. This occurs when the air outlet temperature exceeds 70 degrees. Allow the room to cool down before restarting the unit.
What does E0 code mean on TriStar Air Conditioner?
If your TriStar Air Conditioner displays an E0 code, it indicates that the room temperature sensor has failed and needs to be replaced.
What to do if my TriStar AC 5529 shows E2 code?
If your TriStar Air Conditioner displays the E2 code, it means the water tank is full. Please empty the water tank to resolve this issue.
How to fix a TriStar Air Conditioner that won't start?
If the TriStar Air Conditioner unit does not start, it could be due to a few reasons: * The water full indicator lamp might be blinking because the water tank is full. In this case, drain the water out of the water tank. * If you are in electric heating mode, the room temperature might be higher than the setting temperature. Adjust the temperature accordingly. * If you are in cooling mode, the room temperature might be lower than the setting temperature. Adjust the temperature in this case.
Why is my TriStar Air Conditioner so noisy?
If your TriStar Air Conditioner is noisy, make sure it is placed on a flat, level ground. Also, the sound may be from the flowing of the refrigerant inside the air conditioner.
What to do if TriStar AC 5529 auto power-off in heating mode?
If the TriStar Air Conditioner automatically powers off in heating mode, it is due to the heating protection feature. When the temperature at the air outlet exceeds 70 degrees, the unit will power off automatically. Allow the room temperature to cool before restarting the unit.
What does E0 code mean on a TriStar Air Conditioner?
If your TriStar Air Conditioner displays an E0 code, it indicates that the room temperature sensor has failed. Replace the room temperature sensor.
Specific information regarding appliances with R 290 refrigerant gas.
Details on how to operate the air conditioner in cooling mode.
Details on how to operate the air conditioner in dehumidifying mode.
Instructions for setting the timer ON and OFF functions.
Information regarding the drainage of collected water.
Step-by-step guide for installing the hot-air exhaust hose.
Instructions for fitting the window slider kit to the window opening.
Instructions for cleaning and maintaining the air filter.
General| Type | Monobloc mobile air conditioner |
|---|---|
| Timer type | Digital |
| Cord length | 1.8 m |
| Noise level | 65 dB |
| Castor wheels | Yes |
| Number of speeds | 2 |
| Airflow (low speed) | 280 m³/h |
| Water tank capacity | 0.5 L |
| Airflow (high speed) | 320 m³/h |
| Refrigerating medium | R290 |
| Cooling capacity (max) | 9000 BTU/h |
| Dehumidifying capacity | 1.2 l/h |
| Air conditioner functions | Cooling, Dehumidifying, Fan |
| Refrigerating medium weight | 160 g |
| Suitable for room area up to | 80 m² |
| Cooling capacity in watts (max) | 2630 W |
| International Protection (IP) code | IP20 |
| Cooling capacity in watts (nominal) | - W |
| Cooling energy efficiency (EER, W/W) | 2.61 |
| Heating energy efficiency (COP, W/W) | - |
| Current | 4.5 A |
| Connected load | 980 W |
| Power plug type | Type F (CEE 7/4) |
| AC input voltage | 240 V |
| AC input frequency | 50 Hz |
| Energy efficiency class (cooling) | A |
| Hourly energy consumption (cooling) | - kWh |
| Display type | LCD |
| Product color | White |
| Housing material | Acrylonitrile butadiene styrene (ABS) |
| Quantity per intermodal container (20ft) | 216 pc(s) |
| Quantity per intermodal container (40ft) | 452 pc(s) |
| Quantity per intermodal container (40ft, HC) | 674 pc(s) |
Weight and Dimensions| Width | - mm |
|---|---|
| Weight | 19000 g |
| Package depth | 373 mm |
| Package width | 318 mm |
| Package height | 878 mm |
| Package weight | 21000 g |
To Next Page
