Triumph NTO-9AE User Manual (English)

Other manuals for Triumph NTO-9AE

Questions and Answers:

O
olewisAug 1, 2025
What to do if the motor is not running on my Triumph NTO-9AE?
- J
  Jeffrey WilliamsonAug 1, 2025
  If the motor of your Triumph Lifting Systems isn't running, it could be due to several reasons. A breaker or fuse might have blown, in which case you should call an electrician. Alternatively, the motor thermal overload may have tripped; if this is the case, wait for it to cool down. Faulty wiring connections or a defective button could also be the cause, and for these, you should contact an electrician for assistance.
D
Devin HughesAug 6, 2025
Why does the motor hum but not run on my Triumph NTO-9AE Lifting Systems?
- J
  John YoungAug 6, 2025
  If your Triumph Lifting Systems motor hums but doesn't run, several factors could be responsible. The impeller fan cover might be dented, requiring you to take it off and straighten it. Faulty wiring, a bad capacitor, or low voltage could also be the cause, and for any of these, it's best to call an electrician. Additionally, the lift might be overloaded, in which case you should remove excessive weight.
B
brownmeganAug 10, 2025
How to fix oil leaks in Triumph Lifting Systems?
- B
  Bobby StephensAug 10, 2025
  Oil leaks in your Triumph Lifting Systems can stem from several issues. If the leak is around the tank-mounting flange and the oil reservoir is overfilled, check the oil level to the tank, ensuring it's two inches below the flange. If the leak is around the rod end or breather end of the cylinder, it indicates that the rod seal or piston seal of the cylinder is out, respectively, requiring you to rebuild or replace the cylinder.
T
Tammy BaileyAug 14, 2025
What to do if the motor runs but the lift does not rise on my Triumph NTO-9AE?
- M
  Morgan SalinasAug 14, 2025
  If the motor runs but the lift does not rise on your Triumph Lifting Systems, there are a few potential causes: * A piece of trash might be under the check valve. Try pushing the handle down and the up button simultaneously for 10-15 seconds to flush the system. * The clearance between the plunger valve of the lowering handle might be too small; ensure it's 1/16”. * The ball and seat of the check valve may be dirty; remove the check valve cover and clean them. * The oil level might be too low; it should be just under the vent cap port when the lift is down.
A
amandahendersonAug 19, 2025
Why does my Triumph NTO-9AE make excessive noise?
- M
  michellebanksAug 19, 2025
  Excessive noise in your Triumph Lifting Systems can be due to a few reasons. The leg of the lift might be dry and need grease, so grease the legs. Alternatively, the cylinder pulley assembly or cable pulley assembly might not be moving freely, in which case you should grease the pulley assembly. Finally, there may be excessive wear on the pins or cylinder yoke, requiring you to replace them.
R
Richard PierceAug 22, 2025
Why does oil blow out of the breather of the power unit on my Triumph NTO-9AE?
- M
  mark16Aug 22, 2025
  If oil blows out of the breather of the power unit in your Triumph Lifting Systems, it could be due to the lift being lowered too quickly while under a heavy load. In this case, remove excessive weight from the lift. Alternatively, the oil reservoir might be overfilled, requiring you to reduce the oil to the correct level.