6 of 9
Arm in Transport Mode
To arm the Triumph Protect+ in Transport Mode,
first press the Arm/Disarm button as normal to arm
the Triumph Protect+. Then, within 3 seconds of the
first button press, press the Programming button
which will disable the movement sensor; the
Triumph Protect+ will chirp a third time (if tones are
enabled) and the indicators will also flash a third
time to indicate the movement sensor has been
disabled.
The motorcycle instrument LED will now double
flash instead of single flash to identify Transport
Mode has been activated.
Transport Mode allows the bike to be moved around
(for example when cleaning) or transported in a van
without the Triumph Protect+ triggering due to
movement.
Note:
• Ignition detection and ECU protection switch
detection remain fully active.
To exit Transport Mode simply disarm the Triumph
Protect+ using the Arm/Disarm button and rearm
the Triumph Protect+ if required.
Long Term Storage Mode
Long Term Storage Mode, also known as ‘Winter
Mode’ is used for motorcycles that are not ridden
for long periods and which are stored securely.
When in this mode the Triumph Protect+ draws
negligible current and will only respond to the
ignition being switched on, the movement sensing
and ECU protection switch detection are
inoperative.
To enter Long Term Storage Mode, disarm the
Triumph Protect+ and with ignition off hold down
both buttons on the two-button remote for
10 seconds. A loud bleep will be heard, and the
Triumph Protect+ system will now be inactive.
To exit Long Term Storage Mode, turn the
motorcycle ignition on and the Triumph Protect+ will
sound a series of fast bleeps that rise in volume.
Press the Arm/Disarm button to disarm the
Triumph Protect+. If the Arm/Disarm button is not
pressed the Triumph Protect+ will trigger fully and
the siren will sound.
Note:
• Long Term Storage Mode should also be used to
prevent the Triumph Protect+ from triggering if
the motorcycle battery needs to be
disconnected for any reason.
Bike Finder
The Bike Finder feature flashes the directional
indicators so that the rider can identify the location
of their motorcycle from afar without disarming the
Triumph Prot e c t+ .
Bike Finder is only operational when the Triumph
Protect+ is fully armed and can be activated by
pressing the Programming button on the remote
control for 3 seconds. The motorcycle indicators will
flash 10 times then stop.
Pressing the Programming button during the
directional indicator flashes will cause the flashing
to stop (Note: no need to press and hold).
The Triumph Protect+ cannot be disarmed whilst
the Bike Finder function is operational.
Your insurance company may not include cover
for an alarm in Long Term Storage Mode.
The level of security is reduced when the Triumph
Protect+ is in Long Term Storage Mode.
Always check the details of your insurance cover
before using the Long Term Storage Mode.
Prolonged storage of the motorcycle with the
Triumph Protect+ armed will result in battery
drain.
Excessive battery drain will cause permanent
damage to the battery.
The motorcycle should be connected to an
appropriate battery conditioner to maintain good
battery condition.