7 of 9
Panic Alarm
Note:
•The Panic Alarm does not operate with the
ignition ON.
The Triumph Protect+ offers a ‘Panic Alarm’ facility
that will cause the Triumph Protect+ siren to sound
and the motorcycle indicators to flash to attract
attention. To activate the Panic Alarm, hold down
the Arm/Disarm button on the remote control for 3
seconds with the motorcycle ignition turned off.
To cease the Panic Alarm, press the Arm/Disarm
button on the remote. The Panic Alarm will run for
approximately 5 minutes unless stopped by the
remote control.
If the Triumph Protect+ is disarmed with ignition off,
then pressing and holding the Arm/Disarm button
for 3 seconds will first arm the Triumph Protect+
before triggering the Panic Alarm. If the Triumph
Protect+ is in the armed state, then pressing and
holding the Arm/Disarm button for 3 seconds will
disarm the Triumph Protect+ before triggering the
Panic Alarm feature.
Diagnostics Bleeps
When the Triumph Protect+ is disarmed via the
remote control, a series of bleeps may be heard
signifying the Triumph Protect+ has been triggered.
The explanation for the bleeps is as follows:
• 1 Bleep: Ignition on trigger
• 2 Bleeps: ECU protection switch trigger
• 3 Bleeps: Inclination detection trigger
• 4 Bleeps: Panic Alarm
• 5 Bleeps: Power supply disconnect trigger
• 6 Bleeps: Inclination sensor hardware warning
• 7 Bleeps: Software reboot warning
Battery Monitoring
The Triumph Protect+ monitors the motorcycle battery voltage and, when the Triumph Protect+ is armed,
flashes the motorcycle instrument LED at a variable rate to notify the measured battery voltage. The LED
flash rate is as follows:
Lead Acid Battery
1
Voltages are approximate
2
If the movement sensor is disabled, either by Transport Mode or via programming then the status LED will
flash twice in quick succession to indicate that the movement sensor has been disabled.
Lithium Battery
1
Voltages are approximate
2
If the movement sensor is disabled, either by Transport Mode or via programming then the status LED will
flash twice in quick succession to indicate that the movement sensor has been disabled.
Measured Voltage
1
LED Sequence
2
Indicative Status
Greater or equal to 11.5 V Once every 5 seconds Fully charged battery
Between 11.5 V and 10.5 V Once every 10 seconds Partially discharged battery
Less than or equal to 10.5 V Once every 20 seconds Low battery
Measured Voltage
1
LED Sequence
2
Indicative Status
Greater or equal to 13.2 V Once every 5 seconds Fully charged battery
Between 13.2 V and 12.4 V Once every 10 seconds Partially discharged battery
Less than or equal to 12.4 V Once every 20 seconds Low battery
To Next Page
Loading...
Need help?
General