964
Rear Suspension Linkage Bearings – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Bearing Installation - Rocker
When using a press, always wear overalls, eye, face and hand protection. Objects such
as bearings frequently break-up under load and the debris caused during break-up
may cause damage and injury to unprotected parts of the body.
Never wear loose clothing which could become trapped in the press and cause a
crushing injury to the hand, arms or other parts of the anatomy.
1. Make sure service tool T3880512 is clean.
2. Assemble service tool T3880629 to service tool T3880512, fully engaging the threads.
1. T3880629 - Bearing Installer Handle
2. T3880512 - Needle Bearing Installer 7.5mm
3. Needle roller bearing
3. Position the service tools and bearing (marked side facing outwards) to the rocker on
a press.
To Next Page
Loading...
