Triumph Rocket 3 GT 2021 - Page 1117

1079
2. Screw the installer piece into the mandrel.
1. Mandrel
2. Pivot sleeve
3. Installer piece
Do not attempt to adjust the push rod. The push rod is pre-set at the factory and is
not adjustable. If for any reason the threaded part of the push rod is adjusted the
brake master cylinder assembly must be replaced. Adjusting the push rod affects the
braking characteristics of the front brakes when applied leading to loss of motorcycle
control and an accident.
3. Apply grease, from the kit, to the push rod.
4. Make sure the push rod is fitted to the pivot.
1. Pivot
2. Push rod