Triumph Rocket 3 GT 2021 - Page 1197

1159
3. Align the tyre valve to its mounting hole in the wheel rim. Make sure the tyre valve
orientation is the same as noted for removal.
1. Tyre valve
2. Hole
The edges of the tyre pressure sensor must be parallel to the walls of the wheel well.
Damage to the sensor may result if the sensor is not correctly installed.
4. Fit the sensor to the tyre valve and tighten the fixing of the sensor to 2.1 Nm. Make
sure that the sensor is not forced against the walls of the wheel well while tightening.
1. Tyre pressure sensor
2. Tyre valve
3. Fixing