Triumph Rocket 3 GT 2021 - Page 1256

1218
Mirrors – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
NOTICE
Make sure the friction ring fully fitted to the handlebar and is flush with the end of the
handlebar.
Make sure the mirror is completely on the the friction ring when tightening the pinch
bolt.
1. Fit the mirror and its friction ring as noted for removal and tighten the pinch bolt to
3.5 Nm.
NOTICE
When fitted, make sure there is a gap between the handlebar end weight and the
mirror.
2. Fit the spacer to the handlebar end weight assembly.