Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Make sure that the battery terminals do not touch the motorcycle frame.
This may cause a short circuit or spark which would ignite battery gases causing a risk
of personal injury.
Perform the following operations:
• Seat - Removal
Before disconnecting the battery or removing a fuse for any reason note and record the
rider's settings. Once the fuse has been refitted or the battery reconnected the rider's
settings should be reset as noted.
If the battery has been disconnected or the fuses removed for any reason advise the
rider to confirm the original mode settings have been correctly set. Failure to reset the
motorcycle to the rider's preferred rider mode settings and subsequently being ridden
may cause loss of motorcycle control and an accident.
Note the fitted position of the battery strap in regards to the battery clamp prior to
removal.
To Next Page
Loading...
