The battery strap must be kept under tension during operation'
Failure to keep the battery strap tensioned will allow the battery to move.
Allowing the battery to move during operation could lead to damage to the battery
and irreparable damage to the motorcycle.
3. Pass the battery strap over the battery strap support and locate to the hook on the
battery clamp.
4. Apply a light coat of grease to the battery terminals to prevent corrosion.
5. Reconnect the battery, positive (red) lead first, tighten the battery terminal to 4.5 Nm
and cover the terminal with the protective cap.
6. Reconnect the battery, negative (black) lead and tighten the battery terminal to 4.5
Nm.
7. Attach the fuse box to the side of the battery box.
1. Battery strap
2. Battery strap hook
3. Battery strap support
4. Positive (red) terminal
5. Negative (black) terminal
Perform the following operations:
1. Seat - Installation
To Next Page
Loading...
