Triumph Rocket 3 GT 2021 - Page 1440

1400
1. Release the fixings and remove the starter motor cover.
1. Fixings M6 x 20mm
2. Fixing M6 x 42mm
3. Starter motor cover
NOTICE
Note the routing of the alternator harness, starter motor cable and the Triumph shift
assist harness for installation.
2. Ease the rubber boot from the starter cable, release the nut and disconnect the cable.
3. Protect the crankcase painted surfaces from damage, using a suitable self-adhesive
tape such as masking tape.
NOTICE
The lower fixing for the starter motor also secures the ground cable and the Triumph
shift assist harness bracket. Note the position of these components for installation.