Triumph Rocket 3 GT 2021 - Page 1458

1418
2. Release the fixings and remove the cooling fan connector. Discard the lock nuts.
1. Connector
2. Bracket
3. Fixings
4. Cooling fan controller
Cooling Fan Controller – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Position the cooling fan controller to its bracket. Fit the grommets, flanged sleeves,
washers and fixings as noted for removal. Tighten the fixings to 3 Nm.