1477
Electronic Systems Configuration and Setup
General Information
Calibration Downloading General Information
The calibration download procedures detailed in the flow charts provided in the
following chapters must be followed precisely. Failure to precisely follow the
procedures may result in permanent damage to the component receiving the
calibration download.
When downloading a calibration, always ensure the calibration selected is correct for
your model and region. Failure to select the correct calibration may result in
permanent damage to the component receiving the calibration download.
When downloading an engine ECM calibration, always ensure the correct calibration is
selected for your fuel type. Engine damage may result if a calibration for an incorrect
fuel type is installed.
Before starting a download, make sure the battery voltage is at least 12.8 Volts. An
approved motorcycle battery charger should be connected to maintain battery charge
during download.
The headlight fuse may be removed prior to starting a download to prevent the
headlight draining the battery. Refer to the label on the fuse box cover for the fuse
location.
Ensure the ignition and engine Start/Stop switches are set to the positions detailed at
the beginning of each download process flowchart.
To Next Page
Loading...
