If a keyless ECM calibration download fails for any reason, it is possible that any
existing software and immobiliser system pairings may have been erased from the
keyless ECM's memory. Where this is the case, the keyless ECM can be recovered as
described below.
If after completing this procedure, the download continues to fail, contact Triumph
Service.
Stage 1 - Check Instrument and Headlight Behaviour at Ignition ON:
1. Make sure a paired key is in range.
2. Press the power ON/OFF button.
3. Do the Instruments and headlights turn ON?
Yes - The immobiliser system pairings have been retained. The keyless ECM download
can be restarted and completed using the normal download method.
No - The immobiliser system pairings have been erased. Proceed to Stage 2.
Note: If the headlights illuminate but the instruments do not turn on, this indicates that
the immobiliser system pairings have been retained but the instruments are not
functioning correctly. Recover the instruments by downloading the correct instrument
calibration for your model and region.
Stage 2 - Partial Keyless ECM download:
1. Connect the diagnostic tool.
2. Select the correct Keyless ECM calibration for download using Manual Model
Selection.
3. Do not click Confirm to start the download at this point.
4. Press the motorcycle's Power On/Off button (Note: the motorcycle will nor appear to
power ON).
5. Within 10 seconds, click Confirm to start the download.
6. Follow the on screen instructions at the start of the download.
7. Click Cancel when the download reaches 100% and you are prompted turn the
ignition ON.
To Next Page
Loading...
